148.00 zł (tax incl.)
ST-20 controller for central heating pump
Intended use: The ST-20 regulator is designed to control the central heating water circuit pump. The preset temperature is set using the potentiometer.
Controls for CO pumps
The presented regulator ST-20 is dedicated to controlling the central heating water circuit pump. The desired temperature is set using a potentiometer. The task of the regulator is to switch the pump on when the temperature reaches the preset value and off when the cooker cools down by 2°C below the set temperature.
This mode of operation prevents unnecessary operation of the pump, which saves electricity and prolongs the life of the pump and increases its reliability.
The manufacturer provides a 2-year warranty on the dedicated product with its conditions. We encourage you to visit the downloads tab, where the following documents are available: manual with technical documentation, declaration of conformity, warranty conditions.
FUNCTIONS PERFORMED BY THE CONTROLLER
- control of the CH pump
CONTROLLER EQUIPMENT
- CO temperature sensor
- Potentiometer for setting the desired temperature
CONTROLLER CHARACTERISTICS
- Power supply: 230V / 50Hz +/-10%
- Maximum power consumption of the controller: 2W
- Ambient temperature: 5°C - 50°C
- Maximum load of pump output: 1A
- Temperature setting range CO: 25°C - 85°C
- Hysteresis: 2°C
- Measurement accuracy: 1°C
- Sensor temperature endurance: -25°C - 90°C
- Fuse insert: 1.6A
- Sensor cable length : 1.5m
- Temperature measuring range: 0°C - 85°C
- Distribution class
- I
You might also like
205.00 zł (tax incl.)
ST-21 controller for central heating pump
310.00 zł (tax incl.)
ST-21 controller for hot utility water pump
330.00 zł (tax incl.)